Skip to content
COILS
Concept image (AI-generated)

WIRELESS POWER · CORE TECHNOLOGY

Multi-coil Magnetic Field Beamforming

Automatically creates the optimal magnetic field without precise landing.

Single Tx Coil

Active coils 1 / 1 (always all on)

Field spreads over whole pad → more leakage & loss

Coupling / EfficiencyNormal (Aligned)

COILS Multi-Tx Coils (7)

Active coils 7 / 7

Drive only coils under Rx → min leakage, high efficiency

Offset ~0 mm95.7% (3 kW Tested)
Rx (Receiver Coil)Selectively Driven Tx

HOW IT WORKS

Activating Only Highly Coupled Coils

By estimating the receiver position solely from the transmitting current (no communication required), we drive only the highly coupled coils. This focuses the magnetic field exactly where needed, maintaining efficiency while reducing stray fields.

Conventional Single Coil

Efficiency drops, leakage increases on misalignment

COILS Multicoil

Activates only coils under receiver, maintains efficiency

Publication

S. Huh et al., “Transmitter Coils Selection Method for Wireless Power Transfer System With Multiple Transmitter Coils and Single Receiver Coil,” IEEE Transactions on Power Electronics, vol. 38, no. 3, pp. 4092–4109, March 2023.

95.7%

Transfer efficiency at 3 kW

95.6%

Efficiency at 100mm Misalignment

4.23µT

Magnetic Field at 20cm (Limit 6.25µT)

MISALIGNMENT TOLERANCE (0–100 MM)

100 mm Misalignment: 95.7% → 95.6% (-0.1%p)

3 kW DC-DC Certified Test
100%85%70%55%0 mm (Center)50 mm100 mmSingle Coil (Coupling drops ↓)0 mm · 95.7%100 mm · 95.6%

LOW-EMF SAFETY (AT 20 CM)

4.23 µT Measured — Well Below the 6.25 µT Limit

IEC 61980 Compliant
EMF Safety Limit (Reference)6.25 µT (100%)
COILS 3 kW Multi-coil Station (Tested)4.23 µT (67.7%)

Why leakage stays low: Instead of energizing the entire pad, only the coils directly coupled with the receiver are driven while uncoupled outer coils remain off.

Source: Gyeongbuk Technopark Wireless Power Transfer Technology Center test (2025.10, 3 kW-class system for mobile robots, DC-DC basis) · Meets IEC 61980 EMI requirements View test record →

IP PORTFOLIO

Core Technology Protected by Patents Across Coil, Circuit, Control, and Material

Coil Arrangement Optimization

Optimizes the size, number of turns, and spacing of transmitting coils to minimize interference (coupling coefficient) between coils.

Resonant Compensation Circuit Design

Resolves ZVS failures caused by inter-coil coupling by redesigning the LCC compensation circuit, simplified with fixed components.

Coil Selection Without Communication

Estimates receiver position solely based on transmitting current to drive only the optimal coils and block the rest.

Ultra-light Receiver & Shielding

Uses a nanocrystalline-ferrite hybrid shield to make the receiver light and thin.

Next-Generation Technologies Currently Pending (2026)

Battery state-based power distribution Variable-field charging station for imprecise docking Double-sided wireless power transferSwarm charging priority & fault recovery Low-EMF circuit isolation & frequency spreadVision + Impedance fusion FOD (Foreign Object Detection)Backpack type ultra-thin receiver for humanoidsCoil auto-optimization by coupled EM-thermal-structural analysis

Let's find the right charging setup for your site